造成阳光板破损的因素有哪些你知道吗?
目前,市场上济南阳光板的种类越来越多,使用率也越来越高,那大家对其了解多少,知道在运行过程中造成阳光板破损的因素有哪些吗?。
来源:http://www.wanzhongyue.com/ 日期:2020-07-30 发布人:julong 浏览次数:次
At present, there are more and more types of Jinan sunshine board in the market, and the utilization rate is also higher and higher. How much do you know about it and what are the factors causing the damage of the sunlight plate in the process of operation?
1、无论何种类型的加工,加工的刀具或工具皆不得对板材的非加工部位形成任何损害,切断有必要润滑。由于细微的损害也会致使严峻的开裂。
1. No matter what type of processing, the cutting tool or tool must not cause any damage to the non machined parts of the plate. It is necessary to lubricate the cutting off. Severe cracking can also occur due to minor damage.
2、pc多层板材不能垂直于肋条的方向进行曲折,因这样将不能发生曲面桁条效应,且在应力效果下,促进把板压扁乃至开裂。板子有必要顺着肋条的方向进行曲折。
2. Because of this, the curved stringer effect will not occur, and under the stress effect, the plate will be flattened and even cracked. It is necessary for the board to zigzag in the direction of the ribs.
3、济南阳光板忌讳接触碱性物质及有侵蚀性的有机物质,如碱、碱式盐、胺、酮、醛、酯、醚、酚、卤代烃、芳香烃、甲醇、异丙醇、沥青等。这些物质均会致使极严峻的化学应力开裂。
3. Jinan sunshine board taboo contact with alkaline substances and corrosive organic substances, such as alkali, basic salt, amine, ketone, aldehyde, ester, ether, phenol, halogenated hydrocarbon, aromatic hydrocarbon, methanol, isopropanol, asphalt, etc. These materials can cause severe chemical stress cracking.
4、在装置完成之前不得损坏或揭掉保护膜,以防止擦伤外表。
4. Do not damage or remove the protective film before the installation is completed to prevent scratching of the surface.


5、有必要选用适用于聚碳酸酯塑料的密封胶和密封胶垫。在湿式安装体系中要运用湿式的密封胶膏。一般引荐运用聚硅氧烷胶用于PC板材的湿式安装,但要特别注意,在运用前有必要查看所用胶的化学适应性,肯定不可选用氨基、苯氨基或甲氧基的固化剂来固化的聚硅氧烷胶,由于这些固化剂会致使板材龟裂,特别当有内应力时。
5. It is necessary to select sealant and sealant pad suitable for polycarbonate plastic. Wet sealant paste should be used in wet installation system. It is generally recommended to use polysiloxane glue for wet installation of PC board, but special attention should be paid to the chemical adaptability of the adhesive before use. It is definitely not allowed to use amino, phenylamino or methoxy curing agent to cure polysiloxane adhesive, because these curing agents will cause cracking of the board, especially when there is internal stress.
千万不可用PVC做密封垫,由于PVC中的增塑剂会分出腐蚀板材,致使外表龟裂乃至损害整板。
Do not use PVC as a gasket, because PVC plasticizer will be divided into corrosion plate, resulting in surface cracking and even damage to the whole board.
6、运送、贮存时有必要妥善衬垫、包装、平放,由于板材外表上遭到任何细微的损害(如划痕)都将开展成裂口。
6. During transportation and storage, it is necessary to properly pad, package and lay flat. Any slight damage (such as scratch) on the surface of the plate will develop into cracks.
而且不得将板材与其他化学物质于存放于同一个当地,由于挥发物会致使板材外表的化学应力开裂。在工地上待装的板材也有必要如此做。
Moreover, the plate should not be stored in the same place with other chemical substances, because volatiles will cause chemical stress cracking on the surface of the plate. It is also necessary to do so for the boards to be installed on the construction site.
关于造成济南阳光板破损的六大因素到此就讲解完了,希望上述内容能对大家有所帮助,想了解更多详情,多多关注网站动态,随时欢迎大家前来参观选购。
This is the end of the six factors that caused the damage of Jinan sunshine plate. I hope the above content can help you. If you want to know more details, pay more attention to the website dynamics. You are welcome to visit and purchase at any time.