欢迎访问欢迎访问天桥区欣飞板业经销处!
阳光板、耐力板、FRP(波浪瓦)、灯箱片
我们只生产质量保障的阳光板等产品

统一服务热线:

15806664558

首页>新闻中心>济南阳光板那些“隐藏”的性能
产品分类 PRODUCTS
联系我们

天桥区欣飞板业经销处

联系人:焦经理 

电话:15806664558 

手机:15806664558
          15066129603
          13969012996
地址:济南市历城区历山北路佳园装饰材料南区A7-30号


济南阳光板那些“隐藏”的性能

来源:http://www.wanzhongyue.com/ 日期:2020-09-22 发布人:julong 浏览次数:

济南阳光板具有良好的防紫外线能力,其板材上面有的抗紫外线涂层,可以阻挡紫外线的入侵,保护室内贵重的物品,因此目前很多艺术展览馆都会采用这种板材材料。同时这种板材还具有重量轻的特点,因此无论是施工还是运输,都非常简便。使用这种板材,能够大大的节约运输、装载以及具体施工的成本。这种板材还有良好的阻燃性能,离开火源后能够自行熄灭。
Jinan sunshine board has a good anti ultraviolet ability, and its board has a professional anti ultraviolet coating, which can block the invasion of ultraviolet rays and protect the valuable indoor items. Therefore, many art exhibition halls will use this kind of plate material at present. At the same time, this kind of plate also has the characteristics of light weight, so whether it is construction or transportation, it is very simple. Using this kind of plate can greatly save the cost of transportation, loading and specific construction. This kind of board also has good flame retardancy and can extinguish itself after leaving the fire source.
济南阳光板拥有良好的透光性。目前新型的阳光板其透光率非常高,据研究统计数据显示,这种板材的透光率达到了85%以上,几乎可以和玻璃的透光率相媲美。
Jinan sunshine board has good transmittance. At present, the light transmittance of the new type of sunlight plate is very high. According to the research statistics, the light transmittance of this kind of plate reaches more than 85%, which is almost comparable to that of glass.
不发生黄变,即使在猛烈的阳光曝晒也也不会发生黄变,更加不会出现雾化等现象导致透光率下降,能够维持的透光率长达十年左右的时间。因此,这种板材应用在温室建设中,效果非常良好。
No yellowing, even in the fierce sun exposure will not occur yellow, more will not appear atomization and other phenomena leading to the decline of light transmittance, can maintain the best transmittance for about ten years. Therefore, the application of this plate in greenhouse construction, the effect is very good.
一,阳光板弯曲时应顺着力的方向,切不可 横向弯曲。弯曲半径为板材厚度:中空二层板175 倍一下,三层板185倍以下,四层板200倍一下。 实心耐力板弯曲半径同样为厚度的175倍以下。 板材弯曲部位严禁用螺丝固定。
1、 Sunshine plate bending should be in the direction of force, not transverse bending. The bending radius is the thickness of the plate: 175 times for the hollow two-layer plate, 185 times for the three-layer plate and 200 times for the four-layer plate. The bending radius of the solid endurance plate is also less than 175 times of the thickness. It is forbidden to fix the bending part of the plate with screws.
济南阳光板
Jinan sunshine board
二,在安装屮空板和实心耐力板时,在板与 板接缝处,必须根据板材尺十预留热膨胀间隙, 热膨胀系数为〇.〇65mm/m°C,严禁自攻钉,拉铆 钉等直接穿过板材固定。若一走要穿过时,必须 在板材上钻孔直径大于自攻钉或拉铆钉的直径 100%的扩大孔,再降自攻钉或铆钉通过扩大孔的 圆心,以确保板材能够在任意方向自由伸缩
2、 When installing the hollow plate and the solid endurance plate, the thermal expansion gap must be reserved at the joint of the plate and the plate, and the thermal expansion coefficient is 0.065 mm / m ° C. It is strictly forbidden to fix the plate through self tapping screws and rivets. If it is necessary to pass through, an enlarged hole with a diameter greater than 100% of the diameter of the self tapping screw or rivet must be drilled on the plate, and then the center of the self tapping screw or rivet passing through the enlarged hole must be lowered to ensure that the plate can freely expand and expand in any direction
三,与阳光板接触的密封胶必须选用屮性硅 铜胶,严禁使用碱性,酸性,化学成分不明的含 有溶剂的密封胶。避免阳光板与化学溶剂,溶液和挥发性气体直接接触,若采用稀料稀释的油漆 喷刷m光板支撑架时,必须带油漆完全干燥后方 可安装m光板,严禁用稀料稀释的油漆补刷己安 装阳光板的钢骨架。
3、 The sealant in contact with sunlight plate must be medium silicone copper glue. It is strictly forbidden to use the sealant containing solvent with alkaline, acidic and unknown chemical composition. Avoid direct contact between sunlight plate and chemical solvent, solution and volatile gas. If the support frame of m-smooth plate is sprayed with thinned paint, the M-ray board can be installed only after the paint is completely dried. It is strictly forbidden to use thinner diluted paint to brush the steel framework of the installed sunlight plate.
四,阳光板安装固定务必采用本专用防漏雨 上下成套扣件或本提供的专用平板压条,若采用 其它的平板胶条必须保证胶条的材质为EPDM橡 胶或者丁橡胶,严禁采用聚氯乙烯(PVC),天然橡胶等含有对阳光板有害的物质胶条。
4、 The sun board must be installed and fixed with the special leak proof up and down fastener or the special flat pressing strip provided by the company. If other flat rubber strips are used, the material of the rubber strips must be EPDM rubber or butadiene rubber. It is strictly forbidden to use PVC, natural rubber and other substances harmful to the sunlight plate.
五,安装阳光板时一定要将板材有UV共挤防 紫外线层的带有文字的保护膜一侧朝室外,切不 可装反,安装完成后立立即揭除保护膜,避免经 太阳暴晒后保护膜和阳光板粘连。
5、 When installing the sun board, make sure that the side of the protective film with words on the board with UV coextrusion anti ultraviolet layer should be facing the outside, and it should not be installed in reverse. After the installation, the protective film should be removed immediately to avoid adhesion between the protective film and the sunlight plate after being exposed to the sun.
六,阳光板安装前应揭开距边缘约30mm范 围的保护膜,严禁将保护膜压在型材K,再用刀 划开保护膜的揭膜方法。阳光板的任何部位均不能有划痕。
6、 Before the installation of the sunlight plate, the protective film within the range of 30mm from the edge should be uncovered. It is strictly forbidden to press the protective film on the profile K and then cut the protective film with a knife. There should be no scratches on any part of the sun plate.
相关新闻


  天桥区欣飞板业经销处            联系人:焦经理            座机:15806664558
 手机:15806664558        15066129603       13969012996
  技术支持: 济南诺商   鲁ICP备14016125号 网站地图 XML TXT

统一服务热线

15806664558 

鲁公网安备 37010502001033号

【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】